Set the time and day
- Wait until the second hand reaches 12 o'clock, then pull the crown out to the second click to stop it.
- Turn the crown to set the hands, going four or five minutes past the time you want and then turning back to it.
- Push the crown back in on a time signal to restart the watch.
- To set the day, pull the crown out to the first click, turn it until the right day shows, then push it back in to its normal position.
Good to know
Do not set the day between 8:00 p.m. and 2:00 a.m., or it may not change over the next day.
If the crown screws down, unscrew it before pulling it out and screw it back in fully afterwards; the watch is not water resistant while it is loose.
On a model with an elapsed time bezel, turn the bezel to put its mark on the minute hand; later the minute hand points to the elapsed time on the bezel.
From Casio's guide, page 1